Skip to content

Mon–Fri 8am–7pm · Ships to all 50 states

Ford F-150 Rear End Replacement: 8.8 vs 9.75 Axle, Axle Codes and Buying Used

Ford

Find your F-150 axle code, tell an 8.8 from a 9.75, check the 23S65 recall and match a used rear end to your VIN.

Complete used rear axle assembly for an F-150 rear end replacement

Quick answer: For an F-150 rear end replacement, start with the two-character AXLE code on the driver door label, then count the differential cover bolts (10 means an 8.8-inch axle, 12 means a 9.75). If you have a 2021-2023 truck with the Max Trailer Tow package, check Ford recall 23S65 before you buy anything. Then match a used Ford axle assembly to your VIN and axle code, or send both through our parts quote form.

Last updated: November 20, 2026.

The easiest way to get an F-150 rear end order wrong is to match the year and the cab, but not the axle. Two trucks parked side by side from the same model year can carry different rear axles, different ratios and different differentials. Get those three right and a used rear end from another F-150 is a straightforward bolt-in job. Get one wrong and you are paying freight twice.

Which rear axle does your F-150 have?

Do all four checks, because each one catches something the others miss.

Check

Where to look

What it tells you

AXLE code

Safety Compliance Certification Label on the driver door or latch pillar, below the bar code

Factory ratio and whether it has an electronic locker

Axle tag

Small metal tag held by one of the differential cover bolts

Ratio and build info for the axle actually under the truck (it may have been swapped)

Cover bolt count

Rear differential cover

10 bolts points to an 8.8, 12 bolts points to a 9.75

Ford towing guide

Ford's Trailer Towing Selector for your model year

Decodes the door-label AXLE code for that year

Ford's own instructions are to read the AXLE code off the door label and decode it with the towing guide for your model year (Ford: locating the rear axle ratio). Here is what the 2020 and 2021 F-150 guides list:

Used F-150 style rear axle assembly with the differential housing in the center

Rear axle ratio

Open differential code

Electronic locking code (2020)

Electronic locking code (2021)

3.15

15

L5

Not available

3.31

27

L3

L3

3.55

19

L9

L9

3.73

26

L6

L6

4.10

Not available

L4

L4

Source: Ford 2020 and 2021 F-150 Trailer Towing Selector, Rear Axle Ratio Codes (2021 guide PDF). Notice the 3.15 locker code exists in 2020 and not in 2021. That is exactly why you decode with your own year's guide rather than a forum chart.

One more thing: the door label shows what the truck left the factory with. If the axle tag disagrees with the door code, somebody has already swapped the rear end, and the tag (or a ratio check by a shop) wins.

8.8 vs 9.75: will one swap for the other?

The F-150 has used two semi-float rear axles for most of its modern life: the common 8.8-inch and the heavier 9.75-inch. The numbers are the ring gear diameter. The quick tell is the cover: the 8.8 has a 10-bolt cover, the 9.75 has a 12-bolt cover and a visibly bigger center section.

Most F-150s got the 8.8. The 9.75 shows up on heavier payload and max-tow builds, and the same model year can have either, so the bolt count matters more than the model year.

What does and doesn't interchange:

  • Internal parts: no. Gears, carriers and bearings are different between the 8.8 and 9.75. Even within the 9.75, 2011-and-later gear sets differ from earlier ones.
  • A complete assembly: sometimes. On the same F-150 generation and drive type, a complete 9.75 can often go onto the same spring pads in place of an 8.8. Before you plan that, check the brakes, ABS sensor, driveshaft flange and, on a 4x4, the ratio against the front axle.
  • The 2021-and-later heavy-duty 9.75: treat it as its own part. Ford's recall filing describes the axle on Trailer Tow Max Duty trucks as a 9.75-inch heavy-duty axle with a 3/4-float design, and it is the axle named in the recall below.

Our advice: replace like with like. Same axle size, same ratio, same differential type. A cross-swap is a project, not a repair.

Check the 23S65 rear axle recall first (2021-2023 F-150)

If your truck is a 2021, 2022 or 2023 F-150 with the Trailer Tow Max Duty package and the 9.75-inch heavy-duty axle, stop here and run your VIN at nhtsa.gov/recalls before you price a rear end.

Under NHTSA campaign 23V-896 (Ford 23S65), the rear axle hub bolt can fatigue and break. That can damage the axle hub splines, and the result can be a truck that rolls away in Park when the parking brake isn't set, or a loss of drive power (NHTSA recall report). Ford's report listed 112,965 trucks. The early warning is a clicking noise that turns into a rattle from the rear wheel area. Ford's dealer remedy replaces both rear axle half-shaft and hub assemblies at no charge.

If the recall applies and hasn't been done, that is a dealer visit, not a parts purchase. Until it's checked, set the parking brake every time you park, and have a qualified mechanic look at any clicking or rattling from the rear wheels before you keep driving.

Rear end, center section or axle shaft?

A "bad rear end" can mean three different purchases.

Mechanic inspecting the rear axle and differential under a pickup truck
  • One axle shaft, wheel bearing or seal failed: buy the shaft or bearing, not a whole rear end. Our axle assembly vs axle shaft guide walks through how to tell.
  • Gears or carrier bearings are worn (whine that changes on and off throttle): you can rebuild, or buy a used differential assembly if the housing is good. Rule out tires and wheel bearings first with our differential whine diagnosis guide.
  • Housing bent, gears destroyed, or you need it back on the road this week: a complete used rear end is usually the fastest fix. On a solid-axle pickup, one assembly swap replaces housing, differential and shafts in a single job.

If the gears failed because the fluid was low or burnt, find the leak before the replacement goes in. A pinion seal or axle seal that killed the first rear end will kill the second.

Buying a used F-150 rear end: 8 checks before you pay

Complete used rear axle assembly for an F-150 rear end replacement
  1. VIN and drive type. Model year, 4x2 or 4x4, cab and box. Give the seller the full VIN, not just "2018 F-150".
  2. AXLE code. Photo of the door label. It gives the factory ratio and locker status in one line.
  3. Axle size. 8.8 or 9.75, confirmed by cover bolts or the tag on the donor axle.
  4. Ratio. The donor axle tag should match your code. Ask for a photo of the tag; if it's missing, ask how the ratio was confirmed.
  5. Open or electronic locker. A locker axle needs its actuator and a wiring connector that matches your harness. Ask whether the actuator comes with the unit, and don't swap an open axle into a locker truck (or the reverse) without a shop confirming it.
  6. 4x4 front ratio. The rear ratio must match the front differential. A 3.55 rear under a 3.73 front will bind in 4WD and can damage the transfer case. See our mismatched differential ratio guide.
  7. Brakes and sensors. Ask what's attached: drums or rotors and calipers, the ABS tone ring and sensor, and the parking brake hardware. Confirm the parking brake type matches your truck rather than assuming it does.
  8. Delivery. A complete rear end is heavy freight. Confirm whether it ships to a shop or a residence, and that someone can unload it.

Our used differential and axle ID checklist has photos of where tags and stampings usually sit.

What an F-150 rear end replacement costs

MechanicRank puts a rear differential replacement on a full-size truck or large SUV at $1,315 to $4,425 installed, with 3 to 6 hours of labor, and notes that swapping in a whole used axle is a common fix on pickups (MechanicRank, updated October 2026). For the used vs rebuilt vs new math in detail, see our differential replacement cost guide.

On our Ford axle page we list an estimated $900 to $1,800 for a used F-150 axle. Treat that as a starting point: your quote depends on year, drive type, axle size, ratio and what's attached. Used axle assemblies from iBid Auto come with a 3-month warranty written on the quote, and the ratio and brake setup are confirmed on the quote before it ships. Full terms are on our warranty policy page.

When does used make sense? On a high-mileage work truck, almost always: one matched part gives you the housing, gears and shafts, and the swap is a single job. On a newer truck still under powertrain warranty, talk to the dealer first.

F-150 rear end FAQ

How do I tell if my F-150 has an 8.8 or a 9.75 rear end?

Count the bolts on the rear differential cover. Ten bolts means an 8.8-inch axle, twelve means a 9.75-inch with a larger center section. Confirm with the metal tag on the cover bolt or the AXLE code on the door label, since a previous owner may have swapped the axle.

Where is the axle code on an F-150?

On the Safety Compliance Certification Label on the driver's door or door latch pillar. Look below the bar code for the word AXLE followed by a two-character code, such as 19 or L6. Decode it with Ford's towing guide for your model year, because some codes changed between years.

Will a rear end from a different year F-150 fit?

Sometimes, but year alone doesn't decide it. The donor needs the same generation mounting, axle size, ratio, differential type, brake setup and driveshaft flange. Match by VIN and axle code, and treat any cross-generation swap as a custom job that needs a shop to confirm fitment.

Is there a recall on the F-150 rear axle?

Yes, for certain 2021-2023 F-150s with the Trailer Tow Max Duty package and the 9.75-inch heavy-duty axle. NHTSA campaign 23V-896 (Ford 23S65) covers rear axle hub bolts that can break. Ford dealers replace both rear half-shaft and hub assemblies free. Check your VIN at nhtsa.gov/recalls.

Can I put a 3.55 rear end in a 4x4 F-150 that came with 3.73?

Not without changing the front differential to 3.55 too. On a 4x4, the front and rear ratios must match. A mismatch makes the axles fight each other in 4WD, which causes binding and can damage the transfer case. Order the same ratio your door code shows.

How much does an F-150 rear end replacement cost?

MechanicRank's October 2026 range for a full-size truck rear differential replacement is $1,315 to $4,425 installed, with 3 to 6 hours of labor. Your real number depends on the axle, ratio and labor rate, so get a quote matched to your VIN.

Next step: get a rear end matched to your truck

Send us three things: your VIN, a photo of the door label showing the AXLE code, and a photo of the axle tag if it's still there. We'll match the axle size, ratio and differential type and quote it with freight to your shop or driveway. Start on our used Ford axle assemblies page, browse all used axle assemblies, or go straight to the parts quote form. Not sure of the build? Run your VIN through our VIN decoder first.