The iBid Auto Blog
Buying, maintenance, new models, and everyday cars — from iBid Auto in St. Petersburg.
Showing 49–56 of 61 posts in Car Maintenance & Repair
Show all posts
Is the Driveshaft Causing the Vibration? What to Diagnose Before Buying
Car Maintenance & Repair
Driveline vibration does not always mean the driveshaft is bad. Learn what to diagnose before ordering a shaft, U-joint, or center support.
Buying a Used CVT: Codes, Cooler Service and Calibration Checklist
Car Maintenance & Repair
Buying a used CVT? Verify the exact unit, cooler service, calibration data, specified fluid, included controls, and post-installation procedures.
Before Replacing a Failed Turbo: Oil Lines, Intercooler and Priming Checklist
Car Maintenance & Repair
Replacing a failed turbo? Check the oil circuit, intake, intercooler, exhaust, controls, and priming procedure before installing another unit.
Replacing an Engine After Overheating: How to Prevent a Repeat Failure
Car Maintenance & Repair
Replacing an overheated engine? Use this checklist to identify the original cause and prepare the cooling, oil, intake, and control systems.
Why the VIN Is Only the Start: Used Automatic Transmission Fitment Checklist
Car Maintenance & Repair
Learn why a VIN is only the starting point when matching a used automatic transmission, and what codes, hardware, and programming details to verify.
Axle Assembly or Axle Shaft? A Used-Part Fitment Checklist
Car Maintenance & Repair
Learn how to distinguish an axle assembly from an axle shaft and verify fitment, included hardware, gearing, brakes, sensors, and delivery details.
Buying a Used Driveshaft: Length, End Connections and Fitment Checklist
Car Maintenance & Repair
Before buying a used driveshaft, verify its position, construction, end connections, identification and measurement method with your installer.
ABS Module, Pump or Wheel Speed Sensor? What to Verify Before Ordering
Car Maintenance & Repair
An ABS warning does not identify one failed part. Confirm the fault, part number, assembly scope and setup requirements before ordering.